
Drafty rooms and high gas bills in winter often trace back to an attic that never got properly filled. We blow fiberglass or cellulose into every corner so heat stops escaping and your furnace stops working overtime.

Blown-in insulation in Huntington fills your attic with loose fiberglass or cellulose material that covers every joist, corner, and gap - most jobs are finished in a single day and the difference shows up on the very next heating bill. It is one of the most cost-effective upgrades available for homes in this region. If you are also dealing with uneven temperatures between floors, pairing this service with whole-home insulation gives you the most complete solution.
A lot of Huntington homes were built before the 1980s, when insulation standards were far lower than they are today. Many of them have little or no effective coverage in the attic right now. If your joists are visible when you peek into the attic, that is a clear sign more insulation is needed - and blown-in is the fastest way to fix it.
The U.S. Department of Energy recommends that attics in West Virginia reach a depth of roughly 13 to 16 inches of blown-in material. Learn more about recommended insulation levels from the DOE.
If your gas bill climbs sharply from November through February but your home never quite feels warm, heat is escaping through the attic. Huntington winters are cold enough that a thin or missing insulation layer forces your furnace to run almost continuously. If you have already had the furnace serviced and bills are still high, the attic is the next place to look.
If you peek into your attic and can clearly see the wooden beams running across the floor, your insulation is almost certainly too thin. A properly insulated attic should have material deep enough to bury those joists completely. This is one of the easiest self-checks you can do - no tools needed.
Ice dams form when heat escaping through an under-insulated attic melts snow on the upper roof, which refreezes at the cold edges. Huntington gets enough winter precipitation that this is a real concern for many homeowners. If you have seen ice ridges building up along your eaves, inadequate attic insulation is very likely part of the cause.
Huntington has a large number of pre-1980 homes, most of which left the factory with insulation levels that fall well short of what is recommended today. If your home is more than 40 years old and no one has checked the attic insulation, there is a good chance you are heating the outdoors every winter without realizing it.
We install blown-in insulation in attics, wall cavities, and other hard-to-reach spaces throughout Huntington and the surrounding region. For attics, we use a truck-mounted blowing machine to fill the space evenly to the correct depth - always starting with air sealing around light fixtures, pipes, and the attic hatch before any material goes in. If your project also calls for attic insulation paired with other areas of the home, we can assess the whole house and give you a single coordinated plan.
For existing walls where opening the drywall is not an option, dense-pack blown-in is a technique that fills the wall cavity from the exterior with minimal disruption. This is common in older Huntington homes where the walls were never insulated but the homeowner does not want a full interior renovation. We will walk you through which approach fits your home before any work begins.
Best for homes where the attic is accessible and insulation is thin or absent.
Best for older homes with uninsulated walls where you want to avoid tearing out drywall.
Best for attics with some coverage that has settled or thinned over the years.
Best for homeowners who prefer a recycled-content material with strong fire resistance.
Huntington sits in the Ohio River valley where winter temperatures regularly drop into the 20s and 30s, and the valley traps moisture that makes cold air feel even more penetrating inside a poorly insulated home. A large share of the city's housing was built before 1960 - before modern insulation standards existed - which means many homes have been leaking heat through the attic every winter for decades. Blown-in insulation is one of the fastest and most cost-effective ways to correct that, and most homeowners notice a change in comfort within the first cold snap after installation.
Huntington's above-average humidity also means moisture management matters just as much as thermal performance. Before we blow anything in, we check for signs of moisture intrusion, because wet insulation loses most of its ability to hold heat. We serve the full metro area - including Ashland, KY and Barboursville, WV - so geography is not a barrier to getting this work done.
We ask a few basic questions - your address, home age, and any problems you have noticed. You can expect a response within 1 business day, and most estimates are scheduled within a few days of your first call.
A crew member walks through your attic, measures existing insulation depth, and checks for moisture or ventilation issues. You get a written quote that breaks down exactly what is included - no vague estimates.
We start with air sealing around fixtures, pipes, and the attic hatch before any material is blown. Then we run the hose and fill the attic to the correct depth, checking measurements as we go.
Once the insulation is in, we remove the hose, clean up any loose material, and show you photos of the finished attic so you can see the depth yourself. The insulation works immediately - no curing time required.
We respond within 1 business day. There is no obligation to move forward after the estimate - it is a free on-site visit with no pressure. After you submit, someone from our office will call you to schedule a time that works for you.
(304) 802-8467West Virginia requires insulation contractors to hold a valid state license through the Division of Labor. We carry that license plus full liability and workers' compensation coverage, which means any damage that happens on the job is covered - not your problem.
A lot of contractors skip the air sealing step because it adds time. We include it on every blown-in job because insulation without air sealing leaves gaps that undercut the whole project. You are not paying for a shortcut.
We cover the full tri-state metro area from Huntington outward, including Ashland, Barboursville, Charleston, and Beckley. One call gets you covered regardless of which side of the state line you are on.
We show you photos and measurements before and after every job. You can see exactly what was done and verify the depth of the new insulation yourself - no guessing, no taking our word for it.
Our licensing, our air-sealing process, and our documentation standards are not extras - they are the baseline. The North American Insulation Manufacturers Association sets the professional standards we follow on every project.
Whole-home insulation assessments that cover the attic, walls, and crawl space together for maximum comfort gains.
Learn moreDedicated attic insulation service that stops heat loss at the top of your home before it drags up your utility bills.
Learn moreHuntington winters are not getting shorter - the sooner your attic is properly filled, the sooner you start saving on every heating bill.